User-added image
Place Preprogrammed Sensors—Micro Sensor:
 
IMPORTANT: NEVER REMOVE THE ANTENNA
NOTE: PROGRAMMED SENSORS HAVE UNIQUE PROPERTIES BUILT IN. DOOR SENSORS HAVE AN ENTRY DELAY OF 30 SECONDS, AND AN EXIT DELAY OF 60 SECONDS. WINDOW SENSORS HAVE AN ENTRY DELAY OF 0 SECONDS. ENSURE YOU PLACE THEM IN THE CORRECT LOCATIONS.
 
 
Various orientations between the Sensor and Magnet may be used as long as they are no more than 1/2”distance apart.
1. Once you have determined appropriate location and orientation for Sensor and Magnet remove adhesive sticker and place in desired location   Note: Make sure centering markers (located on the flat inner surface of both Magnet and Sensor) are lined u
Note: WHEN POSSIBLE, PLACE THE SENSOR ON THE STATIONARY FRAME OF DOOR OR WINDOW, AND PLACE THE MAGNET ON THE DOOR OR WINDOW ITSELF
*If you desire a more thoroughly disguised antenna, you may apply a light glue or adhesive to attach it to the frame of your window or door. It is important to remember not to fold or conceal the antenna underneath the sensor—the antenna must be free and clear of the body of the sensor in order for it to function properly.
2. With system disarmed, test Sensor by opening door or window. Correct setup will generate a chime sound
 
 
To Change Preprogrammed Sensors:
IMPORTANT: NEVER REMOVE THE ANTENNA!
1)  Press MENU on Console
2)  Scroll to Security Setup and press SELECT
3)  Enter Master Code*
4)  SCROLL to Sensors
5)  SELECT Sensor to be modified
6)  Use MENU to select and change sensor attributes
 
To Add Additional Sensors:
IMPORTANT: LEAVE PINK BATTERY TAB IN PLACE – DO NOT REMOVE UNLESS INSTRUCTED TO DO SO AND NEVER REMOVE THE ANTENNA!
1)  Press MENU on Console
2)  Scroll to Security Setup and press SELECT
3)  ENTER Master Code*
4)  SCROLL to Sensors and press SELECT
5)  SCROLL to <Add New> and press SELECT
6)  SCROLL to Micro Sensor and press SELECT   
7)  When prompted by Console, pull pink battery tab from Sensor
((DO NOT PULL THE ANTENNA: if you have removed tab previous to this step, see section labeled “If you pulled out the battery tab before prompted to do so” below)
8)   Edit Sensor name
• To change Sensor name press DELETE to remove default name
•  Using keys on Console, type in desired name
•  Press OK 
9)  Select Sensor placement using Console: SCROLL to Door or Window and press OK
10)  Alarm Type: Scroll to Stay & Away, Away Only, or Convenience and press OK
11)  To complete sensor registration, separate Magnet from Sensor, then place them back together. Your Console will make an audible chime and your sensor will be added.
 
If you pulled out the battery tab before prompted to do so:
1)  Gently open Sensor and repeat steps 1-6   Note: Make sure there is space between metal clip and round battery. Either put battery tab back or put piece of paper between clip and round battery (clip and battery cannot make contact while being added)
2)  When Console prompts you to pull battery tab, remove piece of paper or replaced battery tab (or press down on the metal clip) so it makes direct contact with circular battery.
3)  Replace back of Sensor and proceed to next portion of setup (Step 8 above)
 
 
Test Your Sensor:
1)  Line up Sensor and Magnet in closed position, then slightly separate from each other. Once they are separate, Console will make an audible chime. This is how you know you have set up your Sensor correctly.